Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2008 mustang thermostat removal
Viewing all articles
Browse latest Browse all 10

Honda Civic Thermostat Removal and Installation Procedures

0
0

The Thermostat in your Honda Civic is an effective component of the cooling system. However, as soon as its thermal mechanism fails and stops regulating engine temperature, it must be changed to stop engine overheating or underneath-temperature operation. You’ll be able to install a new Thermostat with a few widespread tools.

Honda Civic Thermostat Removal Procedures

1. Place a drain pan below the radiator drain valve and take away the radiator cap.
2. Open the radiator drain valve and remove at the least 2 quarts of coolant. Shut the drain valve.
3. Increase the front of the automobile utilizing a flooring jack and safely assist it on two jack stands.
4. Remove the splash protect from the underside of the engine with a wrench or ratchet and socket.
5. Disconnect the lower radiator hose on the thermostat housing on the engine side. Use a Phillips screwdriver, rib joint pliers or ratchet and socket, depending on clamp type used on your explicit Honda Civic.
6. Unscrew the three thermostat housing mounting bolts with a ratchet and socket.
7. Take away the thermostat housing, thermostat unit and O-ring or rubber seal.

Honda Civic Thermostat Installation Procedures

1. Set the brand new thermostat in place together with a brand new O-ring or rubber seal.
2. Set up the thermostat housing and start the three mounting bolts by hand to avoid damaging the threads. Tighten the mounting bolts.
3. Join the lower radiator hose to the thermostat housing and tighten the clamp.
4. Re-install the splash defend to the underside of the engine.
5. Refill the cooling system with a solution of 50 p.c water and 50 percent antifreeze.
6. Change the radiator cap. If your Honda Civic got here geared up with a bleeding screw or valve on the thermostat housing, bleed the cooling system.

Honda Civic Thermostat Bleeding Procedures

1. Start the engine and let it idle for three minutes.
2. Loosen the bleed screw on the thermostat housing with a wrench or ratchet and socket, simply enough to let the air bleed through.
3. Tighten the bleed screw when the coolant begins to leak by way of the bleed screw.
4. Turn the engine off.
5. Wait about 15 minutes to let the engine quiet down and add coolant to the reservoir tank. Ensure the level reaches between the “Low” and “Full” marks.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images